The PWM transfervoltage moduleLC-LM358-PWM2V converts the PWM digital signals into 0 to 10V analog signals.
It can be used as signal interface switching for PLC or other industrial control boards. The output voltage is regulated by adjusting the duty ratio of the PWM. The modules are small in size and easy to use in different places.

Features:

• MCU embedded technology
• Easy to operate, fine tuned by potentiometer
• Select the PWM signal input level range through short-circuit
• The module is smaller, easy to carry and use

Parameter:

• Work Voltage: DC 12V-30V; (> 100MA)
• PWM Receiver Frequency: 1KHZ-3KHZ
• PWM signal input level range:
• The peak of 4.5V to 10V level. The short cap install in 5V. This level is used for normal controller or 5V MCU
• The peak of 12V to 24V level, so inserted in 24V. The short cap install in 24V. This level is used for normal PLC controller
• Conversion range: 0%-100% PWM to 0-10V
• Allowable error: 5%

Pin Definition:

1. VCC -Working power 12-30V
2. GND -Ground
3. PWM Input PWM signal positive
4. GND -Input voltage ground
5. VOUT-Output voltage: 0-10V
6. GND Output ground